Adjusting The Table Height - ATIKA ASP 8 N Bedienungsanleitung

Adjusting the table height

Upper table plate position
for logs up to 500 mm
Middle table plate position
for logs up to 700 mm
Lower table plate position
for logs up to 1050 cm
1. Release the locking hooks.
2. Pull the table out.
90°
3. Use the table in a position that comes close to the log
length and secure it with the locking hooks.
Adjusting the splitting cross:
1. Loosen star grip
screw.
2. Move the splitting
cross to the
correct position
(The star grip
screw is beyond
Splitting cross
the borehole in
the splitting
blade).
3. Mount star grip screw.
Star grip screw
Splitting short wood:
1. Upper position of table plate.
2.
Place the log on the splitter's table plate.
Only split the logs in the direction of the wood fibres.
3. Hold the log tight with the clamping claws.
Splitting long wood:
1. Middle or low
position of table or
base.
2. Remove the
splitting cross.
3. Place the log on
the splitter's table.
Possible
malfunction when
cleaving logs: The log
to be cleaved is not
cleaved right through,
jams on the cleaving
blade and is pulled up
during the blade's
return movement.
In this case, proceed
as follows:
1. Switch off the
device.
2. Depending on the
log still to be
cleaved fix the
table plate in the
middle or upper position.
3. Switch on the device and continue the splitting operation.
Never try to split two logs at once.
Never try to remove or replace the log during the
splitting process.
Never try to force the splitting of the log by maintaining
the pressure for several seconds. This can lead to damage
to the machine.
Position the log on the table again and repeat the splitting
phase, or put the log on one side.
21