Configuring The Function; The Function Layout; Defining Sequence Points - Elektro-Automatik PSI 9080-100 Bedienungsanleitung

Using the power supply
Overview of the display elements of the function manager:
6.12.1 Configuring the function
M

+ Function +

The menu page Function
selection:

Setup function

Sequence 1

Sequence 2

Sequence 3

Sequence 4

Sequence 5

6.12.2 The function layout


Setup function +
You can define the operation mode of the power supply and
the repetition rate here.

Function mode
(also see U/I/P or U/I/R operation mode in
section „7.1 Defining operation parameters")
=U/I/P use U/I/P operation mode
=U/I/R use U/I/R operation mode

Funct.cycles
= {1..254} it is repeated n times
= ∞ it is repeatedly infinitely
© 2007, Elektro-Automatik GmbH & Co. KG
leads to the following menu

Link sequences to one function
Task: 1 2 3
Seq.: {-,1..5} {-,1..5} {-,1..5} {-,1..5} {-,1..5}
Beneath the particular tasks you can define of which se-
quences the function will consist and in which order the
sequences are used. The symbol „-" indicates, that the task
is not defined and thus won't be processed.
6.12.3 Defining sequence points

The menu page Sequence {1..5}
where the sequences are edited.

Sequence {1..5} +
It leads to the following menu selection:

Sequence {1..5} (number of the sequence to edit)

Sequence control

Sequence points 0-4

Sequence points 5-9
The repetition rate of the sequence, the maximum power and
the internal resistance (optional, has to be unlocked) can be
configured here, as well as the sequence points.
EN
4 5
leads to the menu page
51