Elektro-Automatik PSI 9080-100 Bedienungsanleitung Seite 53

Using the power supply
Before the function manager is really setting the power supply
you can simulate the function on the display. During this
- the output is not switched on and
- the sequence points are processed step by step and can
be verified this way.
The execution is also controllable via communication with an
interface card. Here you can additionally set one stop point
at one of the 50 sequence points. This sequence point is
processed and the sequence/function is then halted.
ESC
The ESC key exits the function manager and re-
turns to the former state of the power supply.
STEP
The STEP key is used to run a sequence step-
wise. The current sequence point is excuted after the key
was pressed. After the „step" has been executed, the set
values, which are displayed in upper right corner of the
display, are set.
RUN
The RUN key starts the function manager and the
function is run as it was defined. The sequence points are
then processed consecutively.
Example for a simulation during standby:
GO
Use the GO key to continue the function after
was stopped.
NEW
Alternatively, you can reset the function manager
to the start of the current function with the
© 2007, Elektro-Automatik GmbH & Co. KG
NEW key.
EN
5