Stand-Alone Mode - EuroLite LED KLS-3002 Next Bedienungsanleitung

System settings

Stand-alone mode

Automatic mode
In automatic mode, 20 different show programs are available that run at an adjustable speed.
1 Press the MENU button so many times until AUT for automatic mode is indicated in the display. Confirm
with the ENTER button.
2 Use UP and DOWN to select the number of the desired program. Confirm with ENTER. The display
indicates menu item brightness.
3 Use UP and DOWN to adjust the brightness of the program from d.01 (dark) to d.100 (bright). Confirm
with ENTER. The display indicates menu item running speed.
4 Use UP and DOWN to adjust the running speed of the program from S.01 (slow) to S.100 (fast). Confirm
with ENTER.
Sound control
Via the integrated microphone the unit can perfectly reproduce the 20 show programs to the rhythm of the
music (sufficient bass provided).
1 Press the MENU button so many times until SOU for sound control is indicated in the display. Confirm
with the ENTER button.
2 Use UP and DOWN to select the number of the desired program. Confirm with ENTER.
3 Use the rotary control SENSITIVITY to adjust the microphone sensitivity to the sound volume. In case of
missing sound signal, the LEDs are either switched off after 5 seconds or hold the most recent light
effect. This function can be found under the menu item SYS > SOUN.
Individual color mix
In the color mode COL each of the 6in1 LEDs can be individually adjusted for brightness. The spots will
constantly emit the color adjusted. Select ALL to adjust the brightness for all fixtures at the same time.
Select ALON to adjust the brightness for each spot individually.
1 Press the button MENU so many times until COL is indicated in the display. Confirm with the ENTER
button.
2 Select the desired mode (ALL or ALON) using the UP and DOWN buttons. Confirm with ENTER.
3 In ALL mode, the display indicates the letter R for the color red and the corresponding brightness value.
4 Use the UP and DOWN buttons to adjust the desired brightness.
5 Confirm with ENTER. Now the color green can be adjusted; then blue, white, amber and UV.
6 The setting of the strobe speed is the final menu item. Use UP and DOWN to select the number of the
desired flash frequency from S.01 (slow) to S.100 (fast) or S.00 (no flashing).
7 In ALON mode, first select the desired spot (PAR1, PAR2, PAR3 or PAR4). Confirm with ENTER.
8 You can now set the brightness for each spot following the same steps as described above.
on
DISP
oFF
on
DISR
oFF
on
IR
oFF
HOLD
SYS
FAIL
BLAC
LAST
SOUN
oFF
on
FOOT
oFF
YES
REST
NO
Display deactivation after 30 seconds
(default setting)
Display always on
Display reversed
Display normal (default setting)
IR remote control activated (default setting)
IR remote control deactivated
Most recent DMX value is held
LEDs are switched off (default setting)
Most recent light effect is held
LEDs are switched off (default setting)
Foot switch activated (default setting)
Foot switch deactivated
Reset to factory settings
No reset to factory settings
28/36
00122642.DOCX, Version 1.0