EuroLite LED KLS-3002 Next Bedienungsanleitung Seite 25

WARNING! Risk of injury caused by falling objects
Devices in overhead installations may cause severe injuries when crashing down. Make sure
that the device is installed securely and cannot fall down. The installation must be carried out by
a specialist who is familiar with the hazards and the relevant regulations.
The device may be fastened to a truss or similar rigging structure using the Omega holders. The device must
never be fixed swinging freely in the room.
1 The rigging structure must support at least 10 times the weight of all fixtures to be installed on it.
2 Block access below the work area and work from a stable platform when installing the device.
3 Use rigging hardware that is compatible with the structure and capable of bearing the weight of the
device. Please refer to the "Accessories" section for a list of suitable rigging hardware.
Screw one clamp each via a M10 screw and self-locking nut onto the Omega holders.
Insert the quick-lock fasteners of the first Omega holder into the respective holes on the control unit.
Tighten the quick-lock fasteners fully clockwise. Install the second Omega holder.
(1) Clamp
(2) Quick-lock fastener
(3) Omega holder
4 Secure the device with a safety bond or other secondary attachment. This secondary safety attachment
must be sufficiently dimensioned in accordance with the latest industrial safety regulations and
constructed in a way that no part of the installation can fall down if the main attachment fails. An
appropriate eyelet is mounted on the device for fixation of the safety rope. Fasten the safety rope in such
a way that, in the event of a fall, the maximum drop distance of the device will not exceed 20 cm.
5 After installation, the device requires inspections periodically to prevent the possibility of rot, deformation
and looseness.
Attaching further lighting effects
OUT IN
POWER OUT
DMX512
T5A/250V
The light set offers mounting points for attaching further lighting effect units (e.g. spot lights, flower effects or
lasers). For this loosen the fixation screw on the upper side, attach the light effect through its bracket and
tighten the fixation screw.
1
2
3
LED KLS-3002
Compact Light Set
T2.5A/250V
POWER IN
100-240V~ 50/60Hz
25/36
POWER OUT
MENU UP DOWN ENTER
MICROPHONE CONTROL
T5A/250V
SENSITIVITY
00122642.DOCX, Version 1.0
IR