INFORMATION
In case of any overflow, turn off the burner immediately. Remove the pots and pan
supports from it. Clean the overflowed material with a dry and absorbent cloth. Pay
attention not to let liquids enter into burners. Clean inside of the burners as well if any
liquid has entered. Do not re-operate the hob before cleaning it.
Please comply with the following rules before cleaning and maintenance:
• Turn the unit off for safety purposes. If your device is set to natural gas then close
the valve. For LPG hobs close pressure reducing valve as well.
• Take out the plug of your unit from wall socket.
• If the hob is hot wait until it cools down.
• Clean glass and stainless steel hobs at regular intervals with appropriate products.
• Cleaning of stainless surfaces should be conducted to avoid any damage to it. After
any cleaning it should be dried with soft cloth.
• In order to avoid any damage to the burning system do not use it when burner
rings are not installed.
• After cleaning of plug and thermocouple, replace the flame spreader.
• Wash the upper burning heads at certain intervals with water and dry. Clean gas
channels with a brush. Pay attention to install the burning heads on their places.
• When you clean the burner do not use acid, thinner, benzene or similar chemical
You need to clean your glass hob and its grills with suitable cleaning agents.
• It should be cleaned with suitable cleaners for stains and oil.
• Harsh cleaning agents, stain removers and detergents, wire wool and sponge sho-
uld not be used.
• Do not allow heating of the pans when empty since the heat accumulated at the
bottom may damage the glass surface.
• No cold liquid should be poured on the glass surface or the burners when they are
hot. The glass may crack due to thermal shock.
EN
46