Kernau KGH 6482 X Bedienungsanleitung Seite 45

A BURNER SR BURNER
1 kW 1.75 kW
G 30-30 G 30-30
mbar LPG mbar LPG
(0,50 mm) (0,65 mm)
G20–20 G20–20
mbar
NATURAL GAS NATURAL GAS
(0,72 mm) (0,97 mm)
WARNING
Make sure that no additional weight to be applied on the gas hose.
Complete the installation by using gasket in the mid-
dle for the LPG hose entrance indicated on the above
figure during the natural gas LPG conversion.
• Use flat sole pans on the hob. In this manner, thermal energy can be conducted the
most effectively.
• It is recommended not to use concave pans.
• Use pans with proper diameters. Do not use smaller pans than the diameter of the
burner. When small pans are used it may cause pot smoking and reduced efficiency
of the hob.
• Use dry sole pans. Do not place the cover of the pan (especially when wet) on the
burner.
• Use a wet cloth to wipe the hob. However, if it becomes dirty, use water with de-
tergent to ensure drying.
Service life of the product will extend and the possibility of problems will decrease
if the product is cleaned at regular intervals.
DANGER
Disconnect the product from mains supply before starting maintenance and cleaning
works.
DANGER
Allow the product to cool down before you clean it.Hot surfaces may cause burns!
R BURNER
3 kW
G 30-30
mbar LPG
(0,85 mm)
G20–20
mbar mbar
NATURAL GAS
(1,15 mm)
1. Nitril/rubber Gasket
2. Elbow pipe
3. LPG hose coupler
WOK BURNER
WOK BURNER
2,5 kW
3,3 kW
Ø100
Ø100
G 30-30 G 30-30
mbar LPG mbar LPG
(0,89 mm) (0,82 mm)
G20 – 20 G20 – 20
mbar mbar
NATURAL GAS NATURAL GAS
(1,28 mm) (1,15 mm)
EN
45
WOK BURNER
3,8 kW
Ø126
G 30-30
mbar LPG
(0,98 mm)
G20 – 20
mbar
NATURAL GAS
(1,35 mm)