Kernau KGH 6482 X Bedienungsanleitung Seite 36

OPERATION OF THE BURNERS AND POWER LEVELS
• Turn the control switch left until reaching to maxi-
mum level. When you press the control switch all
burning igniters will start operating. Release the
switch in few seconds after burning of the burner,
and bring the control switch to the desired flame po-
sition between the maximum and minimum levels.
(Figure 2)
• If the flame is gone when you release the switch, you
should repeat the above process. But this time press
the switch and hold for about 10 seconds.
WARNING
Do not use burning system for more than 15 seconds. If the burner will not be
burned within such time or if the flame will be cut for any reason whatsoever,
repeat starting process after waiting for 1 minute.
• Turn the control switch right to turn the hob off.
• All burners on your hob are equipped with Flame Failure Device. This system will
cut the gas supply to burner if it is extinguished for any reason (overflow, spill,
draft, etc.). In case of such event, turn the knob to "off" position and try to ignite
the burner again.
• The pan diameter and the burner power should match in order to use it the most
efficiently. The diameters proper for each burner are given in the table.
• Select the proper pan diameter and volume in order to use the proper burner.
CLOSING THE BURNERS
FLAME FAILURE DEVICE (FFD)
Figure 3.
USING RIGHT BURNER
EN
36
Figure 2.