Kernau KGH 6482 X Bedienungsanleitung Seite 42

INSTALLATION OF THE HOB IN THE COUNTER
In order to prevent insertion of
particles and liquids between
the hob and the counter attach
the gasket on the hob without
allowing any overlapping befo-
re the installation. (Figure 7)
Place the hob in the middle of
the hole.
Secure the unit on the counter
by using the installation sheet
and screws. (Figure 7 and 8)
• Electric connection should be conducted by a competent and authorized person.
• The electric cable of your hob should not be laid in hot places.
• When the power cable is damaged, it should replaced by the authorized service
dealer.
• No reducer, adapter, and switch should be used for electrical connection since it
will cause excessive heat and fire.
• Plug the electric cable to a grounded wall socket. The manufacturer cannot be held
responsible if you fail to do so.
• The supply data of the electric network should be suitable with the data on the type
label of the unit.
These instructions are prepared for specialist personnel having required competence.
Installation of the equipment should be suitable as per the applicable standards.
All gas related works should be conducted when the electric connection was cut.
The value plate on the hob indicates the gas type intended to be used for use with the
hob. Connection to the gas supply (mains or gas canister) should be done after adju-
sting the hob to the intended supply type. Note that the LPG hoods should have TSE
Installation Clamp
EN
42
Figure 7.
Figure 8.