Kernau KGH 6482 X Bedienungsanleitung Seite 44

EN
44
WARNING
Final Check for any leakage with a water and soap soluton – do not ever use flame.
These instructions are prepared for specialist personnel having required competence.
Installation of the equipment should be according to the applicable standards.
• Wll gas related works should be conducted when the electric connection was cut.
In order to convert the hob, remove the burner plates and burner rings. Unscrew old
injectors, and replace them with the injectors with suitable diameters defined in the
user's manual and assemble all parts. Then, remove knobs and their gaskets and ad-
just gas valves. To do so, burn the burner and set it to minimum flame, and adjust the
screw.
Flow setting screw should be tightened in LPG conversions and it should be loosened
for conversion from LPG to natural gas. After the setting of the hob, complete the
conversion procedure by connecting the rubber seals and knobs in the same order.
These instructions should be used by an authorized service. The products should be
installed as per the regulations in force and in proper manner. Before conducting any
modification, the electrical connections of the hob should be cut.The type label on the
hob indicates the gas type planned to be used with the unit.
These instructions should be used by an authorized service. The products should
be installed as per the regulations in force and in proper manner. Before conduc-
ting any modification, the electrical connections of the hob should be cut.
The type label on the hob indicates the gas type planned to be used with the unit.
After completing the injector installation, check the gas sealing with foam. Apply
foam to the bottom of the injectors for this purpose. Press on the injector with
your finger so that the gas outlet is closed and check for any bubbles on the con-
nection areas of the injector.