Pos: 24.1 /Überschriften/Überschriften 1/U-Z/Wartung @ 0\mod_1199883581050_78.docx @ 36685 @ 1 @ 1
10
Maintenance
Pos: 24.2 /Überschriften/Überschriften 2/P-T/Spezielle Sicherheitshinweise @ 0\mod_1196660495760_78.docx @ 9134 @ 2 @ 1
10.1
Special Safety Instructions
Pos: 24.3 /BA/Sicherheit/Gefahrenhinweise/Ladewagen/Gefahr Wartung allgemein @ 0\mod_1199884069862_78.docx @ 36704 @ @ 1
Danger! - When performing repair, maintenance or cleaning work on the machine, or in
the case of technical intervention, drive elements may start moving.
Effect: Danger to life, injuries or damage to the machine.
•
Switch off the tractor engine and remove the ignition key
•
Secure the machine and tractor against the possibility of rolling back.
•
Switch off the PTO and disengage it
•
After the repair, maintenance and cleaning work or technical interventions are completed,
mount all protective coverings and safety devices properly again.
•
Avoid skin contact with oils, greases, cleaning agents and solvents.
•
In the event of injuries or burns due to oils, cleaning agents or solvents, contact a
physician immediately.
•
All other safety instructions must also be followed to avoid injuries and accidents.
Pos: 24.4 /Überschriften/Überschriften 2/P-T/Probelauf @ 0\mod_1196782963921_78.docx @ 14908 @ 2 @ 1
10.2
Test run.
Pos: 24.5 /BA/Sicherheit/Gefahrenhinweise/Mähwerke/Gefahr - Verwendung von nicht zugelassenen Ersatzteilen @ 0\mod_1196783037140_78.docx @ 14946 @ @ 1
Danger! - Using non-approved spare parts.
Effect: Danger to life, serious injuries or loss of warranty claims as well as exclusion of liability
•
Use only authentic KRONE spare parts and accessories authorised by the manufacturer.
The use of spare parts, accessories or additional equipment not manufactured, tested or
approved by KRONE will exclude any liability for consequential damage.
Pos: 24.6 /BA/Wartung/Hinweis Verschleiss verringern @ 0\mod_1199953505303_78.docx @ 37204 @ @ 1
Note
To ensure problem-free operation of the machine and to reduce wear and tear, specific
maintenance and upkeep intervals must be observed. These include cleaning, greasing,
lubricating and oiling parts and components.
Pos: 24.7 /BA/---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1
Maintenance
63