Attaching The Auxiliary Handle; Attaching And Replacing Roughing / Grinding / Cutting Discs; Switching On And Off - Parkside PWS 230 A1 Bedienungs- Und Sicherheitshinweise Und Originalbetriebsanleitung

is beyond the angle of the auxiliary
handle (see Fig. B). Otherwise you
6
could injure yourself against the grinding or
cutting disc.
j
Open the clamping lever
j
Insert the disc cover guide
projection in the coded groove
9
j
Turn the disc guard cover
position (working position). The closed side of
the disc guard cover
the operator.
j
Close the clamping lever
the disc guard cover
If necessary the clamping force of the connection
can be adjusted by tightening or loosening the
adjuster screw .
10
Ensure that the disc guard cover
on the spindle collar.

Attaching the auxiliary handle

Q
CAUTION! For safety reasons this
device must always be used with the
auxiliary handle
you could become injured.
J
Pull the mains plug out of the mains
socket before you carry out any task
on the device.
j
Screw the auxiliary handle
or on the top of the head of the device.
Attaching and replacing
Q
roughing / grinding / cutting discs
Take note of the dimensions of the roughing /
grinding or cutting discs. The circular hole must fit
on to the mounting flange without play. Do not use
a reducer piece or adapter.
J
Pull the mains plug out of the mains
socket before you carry out any task
on the device.
J
Check the condition of the roughing /
grinding or cutting discs. They must be
free of damage, moisture or cracks.
.
8
with the coded
7
.
16
into the desired
7
must always be facing
7
to firmly clamp
8
in place.
7
sits firmly
7
in place. Otherwise
6
DANGER OF INjURy!
on the left, right
6
DANGER OF INjURy!
Preparing for use / Operation
Otherwise they could break up during use and
cause injury.
DANGER OF BURNS! Always wear
protective gloves when changing a
roughing / grinding or cutting disc.
Roughing / grinding and cutting discs become
hot during use. Do not touch them until after
they have cooled down.
J NOTE: Always ensure the discs are free of dirt
before use.
J
Use only abrasive consumables or tools with
an allowable speed at least as high as the
no-load speed of the device.
J
DANGER OF INjURy! Press the spindle lock
button only after the mounting spindle
11
has reached a standstill.
j
Press the spindle lock button
j
Release the clamping nut
(see Fig. C).
17
j
Place the roughing / grinding or cutting disc on
to the mounting flange
facing towards the device.
j
Then replace the clamping nut
raised side facing upwards, on to the mounting
spindle .
14
j
Press the spindle lock button
j
Tighten the clamping nut
spanner .
17
j
NOTE: Replace a new disc immediately if it
runs unevenly or vibrates after being exchanged.
j
After replacing a disc let the device run under
no-load conditions for 30 seconds as a safety
check. Look out for unusual noises or generation
of sparks. Check that all the fastened-on parts
are correctly attached.
j
Pay attention to see that the arrow showing the
direction of rotation on the roughing / grinding
or cutting discs (including diamond cutting discs)
corresponds with the direction of rotation of the
device (see arrow on the head of the device).
Operation
Q

Switching on and off

Q
Note: Always switch on the angle grinder before
bringing it into contact with the workpiece material.
14
to block the drive.
11
using the spanner
13
with its labelled side
15
, with its
13
to block the drive.
11
again with the
13
GB 15