Replacing The Batteries; Hold Function; Getting Started; Setting The Clock - Philips 7780 Instruction For Use

8 Deutsch 8 Français 8 Nederlands 8 Italiano 8 Español
English

Replacing the Batteries

(1) Be sure that the Voice Tracer is switched off.
Switch off the Voice Tracer by pressing the PLAY/PAUSE button for
a few moments in Stop mode.
­
Do not replace the batteries while the Voice Tracer is switched
on, as this may cause the device to malfunction.
(2) Open the battery cover.
(3) Insert the batteries:
- Make sure that the batteries are inserted properly (si e "AAA") and
close the cover.
- Press the PLAY/PAUSE button for a few moments to switch the
Voice Tracer on.
® Remove the batteries if you will not be using the Voice Tracer for an
extended period. Leaking batteries may damage the Voice Tracer.
® Should your Voice Tracer malfunction, please remove the batteries
and insert them again.
Replace the batteries if the display alternates between status 3 and 4.

Hold Function

1. When the HOLD switch on the left side of the Voice Tracer is in the
Hold position, all buttons on the device are inactive.
2. Slide the HOLD switch to the Off position to enable the buttons on
the Voice Tracer.

Getting Started

Switching the Voice Tracer On
(1) Press and hold the PLAY/PAUSE button for a few moments to switch
on the Voice Tracer. The Voice Tracer is in Stop mode (Figure 6-1)
or Clock Set mode (Figure 6-2).
­
The Voice Tracer switches on in the
same mode that it was in when it was
switched off.
­
If the time is not set, the Voice Tracer
will switch on in Clock Set mode.
­
The Voice Tracer will change to Stop
mode when you set the time or when you press the
STOP/MENU button.
(2) Press and hold the REC button for a few moments to
skip setting the clock and to begin recording immedi-
ately.
(3) If the HOLD switch is in the Hold position, "On Hold" will be
shown briefly on the display, and the display will turn off (Figure
6-3). Unlock the Voice Tracer by moving the HOLD switch to the
Off position.

Setting the Clock

1) Put the Voice Tracer in Stop mode.
2) Press and hold the STOP/MENU button for a few moments to enter
Menu mode. Follow the instructions in the chapter Menu Entry.
Switching the Voice Tracer Off
In STOP or FM Radio mode, you can switch off the Voice Tracer by
pressing and holding the PLAY/PAUSE button for a few moments.
® Switch off your Voice Tracer when you are finished using it for re-
cording or playback for maximum battery life.
6
7
Figure 6-1 Figure 6-2
Figure 6-3