Designated Use - Endress+Hauser Promag 300 Einbauanleitung

2

Designated use

The spare part set and the Installation Instruction are used to replace a faulty unit with a
functioning unit of the same type. Use genuine parts from Endress+Hauser only.
Only original spare part sets, intended by Endress+Hauser for the measuring device, must be
used.
The verification has to be done via W@M Device Viewer; this procedure is explained below.
For some devices there is an overview of spare part sets inside the device. If the spare
part set is listed there, the verification is not required.
1. www.endress.com/deviceviewer
2.
Ser. No.: 12345
Endress+Hauser
Order code Description
3.
=
?
4.
1. www.endress.com/deviceviewer
2. Enter serial number (Ser. No.), search for product
data and click on "spare parts".
3. List of all spare parts sets for the device.
4. Determine the order number of the spare part set.

The spare part set can only be used if the order
number of the spare part set corresponds to the
order number on the spare part list.
EA01199D
5