7.3
Mounting the replacement transmitter
NOTICE
‣
Before installing the replacement transmitter, remove the cover, the electronics etc. as
described in Section 7.2.
‣
Assemble the replacement transmitter in the reverse order.
1 →
1.
‣
To assemble the transmitter version for non-hazardous areas: turn the
transmitter as far as it will go and then turn it back as far as the securing
screw.
2
1.
‣
To assemble the transmitter version for hazardous areas: turn the
transmitter as far as it will go and then turn it back as far as the securing
screw.
NOTICE
‣
For detailed information on the electrical connection, see the "Electrical connection" section
of the Operating Instructions for the device.
‣
For detailed information on commissioning, see the "Commissioning" section of the
Operating Instructions for the device.
Endress+Hauser
3.
7 Nm (5.2 lbf ft)
2.
2.
3.
7 Nm (5.2 lbf ft)
4 mm
4 mm
EA01199D
11