Overview Of Replacement Sensors; Designated Use - Endress+Hauser Promag 500 Einbauanleitung

EA01157D
1

Overview of replacement sensors

The Installation Instructions apply to the following replacement sensors:
Order structure
8*5B**-**XXXXXXXAX*
5*5B**-**XXXXXXXAX*
9*5B**-**XXXXXXXAX*
2

Designated use

The spare part sets and Installation Instructions are used to replace a faulty unit with a
functioning unit of the same type. Only original parts from Endress+Hauser may be used. Only
spare parts kits designed by Endress+Hauser for the measuring device can be used at any
time.
Inspection is performed using the W@M Device Viewer. The procedure involved is described
as follows.
A spare parts overview is located in the interior of some measuring devices. If the spare
parts kit is specified on this list, no inspection is required.
1. www.endress.com/deviceviewer
2.
Ser. No.: 12345
4
Device component
1 × Promass sensor for Proline 500 digital, complete
including sensor nameplate, 1 × Installation Instructions
1 × Promag sensor for Proline 500 digital, complete
including sensor nameplate, 1 × Installation Instructions
1 × Prosonic Flow sensor for Proline 500 digital, complete
including sensor nameplate, 1 × Installation Instructions
Order code Description
3.
=
?
4.
1. www.endress.com/deviceviewer
2. Enter serial number (ser. no.), search for product
data and click Spare Parts.
3. All spare parts for the measuring device are
displayed.
4. Determine the order number of the spare parts kit.

The spare parts kit may be used only if the order
number of the spare parts kit corresponds to an
order number on the spare parts list.
Endress+Hauser