Workplace Safety; Operational Safety; Electromagnetic Compatibility; Product Safety - Endress+Hauser iTEMP TMT162 Bedienungsanleitung

iTEMP TMT162
2.3

Workplace safety

For work on and with the device:
‣
Wear the required personal protective equipment according to federal/national
regulations.
2.4

Operational safety

CAUTION
L
Risk of injury!
‣
Operate the device in proper technical condition and fail-safe condition only.
‣
The operator is responsible for interference-free operation of the device.
Power supply
‣
The device must only be powered by a 11.5 to 42 V
02 (low voltage / current) with short circuit power limitation to 8 A / 150 VA.
Hazardous area
To eliminate a danger for persons or for the facility when the device is used in the hazardous
area (e.g. explosion protection or safety equipment):
‣
Based on the technical data on the nameplate, check whether the ordered device is
permitted for the intended use in the hazardous area. The nameplate can be found on the
side of the transmitter housing.
‣
Observe the specifications in the separate supplementary documentation that is an integral
part of these Instructions.

Electromagnetic compatibility

The measuring system complies with the general safety requirements in accordance with EN
61010-1, the EMC requirements of IEC/EN 61326 and NAMUR Recommendation NE 21 and
NE 89.
2.5

Product safety

This measuring device is designed in accordance with good engineering practice to meet state-
of-the-art safety requirements, has been tested, and left the factory in a condition in which it
is safe to operate.
It meets general safety standards and legal requirements. It also complies with the EC
directives listed in the device-specific EC Declaration of Conformity. Endress+Hauser confirms
this by affixing the CE mark to the device.
Endress+Hauser
voltage supply according to NEC class
DC
Basic safety instructions
29