Program Commands - Medion MD 82467 Bedienungsanleitung

Program commands

To programme, proceed as follows:
1. Place the remote controls with the infrared diodes facing each other
spaced 15 to 50 mm apart on the table. The infrared diodes must be
pointing directly at each other.
2. Keep the SETUP key pressed for approx. 3
seconds until
3. Press SETUP briefly three more times to open
LEARN SETUP
the
4. Press OK to open the learn mode.
5. Confirm once again with OK.
6. Now select the mode key on which the device of
the original remote control was programmed.
LEARN KEY
7. The
key on the universal remote control that is to be
assigned to the original remote control function
(not: SETUP or MACRO).
8. In the display you now see
the key on the universal remote control whose
function should be assigned to the universal
remote control. Keep this key pressed until
either the
appears.
9. The following query appears:
you want to perform additional learn functions,
confirm with OK. The
appears again. Proceed as described in point 7.
If you want to end the learn function, press EXIT.
The remote control returns to normal operation.
CODE SETUP
appears.
menu.
prompt appears. Now select the
LEARNING
SUCCESS LEARN ERROR
or
LEARN KEY
. Now select
message
LEARN MORE?
. If
prompt
25