Incorporating Delays; Executing Macros; Deleting Macros - Medion MD 82467 Bedienungsanleitung

Incorporating delays

It can be useful to incorporate a time delay before a command step in order to
take the warm-up phase of the TV set into consideration, for example. The
standard delay between the infrared signals is equal to
half a second.
1. While entering the steps (see Point 7 above) press the
PAUSE key at the point where the time delay should
be incorporated.
DELAY TIME?
The
2. Press a number key corresponding to the seconds by
which you would like to delay (e.g. "3" for a 3-second
delay). The maximum delay is 9 seconds.

Executing macros

To execute a macro, briefly press the MACRO key once
in normal mode. The following message appears:
KEY?
.
Then press the number key where the macro was saved
within 20 seconds (1, 2 or 3).
While the macro is running,
along with the transmission symbol.
If no macro is saved under the selected numberkey, the
MACRO 1 VOID
message

Deleting macros

Perform steps 1 to 3 as described in section
"Programming macros" on page 27. The
display appears.
1. Use the arrows
mode.
2. Press OK" The following message appears:
MACRO KEY?
3. Press the number key where the macro is stored
for the macro that you would like to delete.
CONFIRM CLEAR
4. The
5. Confirm once again with OK.
appears again in the display, followed by the
confirmation message
The remote control returns to normal operation.
28
query appears.
MACRO 1
(or
appears.
to select the
.
prompt appears.
SUCCESS
MACRO
2 3
or ) appears
MACRO SET
MACRO CLEAR
PLEASE WAIT
.