Program Commands; Deleting Functions - Medion LIFE E74003 Handbuch

Program commands

To programme, proceed as follows:
1 Place the remote controls with the infrared diodes facing each other spaced
approx. 30 mm apart on the table. The infrared diodes must be pointing
directly at each other.
2 Press down the required source key of the universal remote (TV1, TV2,
SAT1, SAT2, DVD, VCR, AUDIO, TUNER, TAPE, AUX), together with
the LEARN key, until the LED switches on. The universal remote will then
be in the Learn mode.
3 Press the key on the universal remote control that is to be assigned to the
relevant function. The red LED flashes.
4 Press the key of the original remote which is intended to be transferred. The
code will have been accepted if the universal remote flashes three times.
5 Repeat steps 3 and 4 for every function to transmit.
6 Stop the programming by pressing the LEARN key.
The Learn mode will be ended automatically, if no key has been pressed
within 14 seconds.

Deleting functions

Setting the universal remote back
 Press down any required source key (TV1, TV2, SAT1, SAT2, DVD, VCR,
AUDIO, TUNER, TAPE, AUX), together with the 0 Key, for approx. 2
seconds, until the LED flashes three times.
All the commands for all source keys and all the functions programmed will be
set back; the remote will be set back and all content deleted.
Deleting the programmed commands of all source keys
To delete all learnt commands altogether, proceed as follows:
 Press down the TV1 key, together with Key 6, for approx. 2 seconds, until
the LED flashes three times.
All codes that were programmed using the learn function have now been
deleted.
12