Set timer
The universal remote control has two timer functions:
•
a sleep-timer for the TV (automatic switch off after 1
to 90 minutes); "Zzz" appears in the display:
•
four additional times for customisable commands
(e.g. switching to another programme); the bell
symbol appears in the display.
TV sleep-timer
Set sleep-timer
1.
Keep the SETUP key pressed down for approx. 3
seconds, until
2.
Press SETUP briefly twice more to open
SETUP
.
3.
Press OK" The
4.
Press OK" The
5.
Press OK" The number of minutes flash in the
display.
6.
Use the arrows
which the TV device should switch itself off
automatically.
7.
Press OK" The
appears along with the TV timer symbol "Zzz".
8.
Lay the universal remote control down so that it
is pointing towards the device and is not
obstructed.
Switch off sleep-timer
If a sleep-timer is on ("Zzz" appears in the display)
TV SLEEP SET
display instead of
steps described above.
1.
Perform steps 1 to 4 as described above. The
SLEEP CLEAR
2.
Press OK" The message
displayed.
3.
Press OK" The
appears.
CODE SETUP
appears.
TV SLEEP SETUP
menu is displayed.
TV SLEEP SET
display appears.
to enter the time after
SUCCESS
confirmation message
when you perform the
display appears.
CONFIRM CLEAR
SUCCESS
confirmation message
TIMER
TV SLEEP CLEAR
TV
is
appears in the
21