Command Timer; Program The Command Timer - Medion MD 82467 Bedienungsanleitung

Command timer

The clock must be set for this timer.
You can use the command timer to program a function that is to run
automatically at a particular time within the next 24 hours. The command series
can contain up to four commands, the first command must always be the
selection of a mode key.
The following keys are not available for the remaining three commands: the
mode keys, the joystick (arrows and OK), MACRO, SETUP, EXIT.
You can create four command timers (Timer 1, Timer 2, Timer 3, Timer 4).
When the command is run this timer is automatically deleted.

Program the command timer

Example: This is how to program a command timer to control a recording on a
DVD recorder.
1. Keep the SETUP key pressed down for approx. 3
seconds, until
2. Press SETUP briefly twice more to open
SETUP
.
3. Press OK The
4. Use the arrows to select
menu 3.
5. Press OK" The
6. Press OK The time when the command will be
run appears.
The hours flash.
7. Use the arrows to set
confirm by pressing OK.
The minutes flash.
8. Use the arrows to set
confirm by pressing OK.
TIMER 1 MODE?
9. The
the command. Use the mode key to select the
device on which the command should be
performed.
In our example, DVD if the DVD recorder was programmed on this key.
10. Press OK. You are prompted to make the first
TIMER 1 KEY1
entry
In our example: Use the number keys to select
the programme.
If no other input is needed, press OK or EXIT.
TIMER 1 KEY2
11. The
second command.
3
If a command timer has already been entered, then
22
CODE SETUP
appears.
SLEEPTIMER TV
menu is displayed.
the
TIMER 1 SET
display appears.
the hour and
the minutes and
display prompts you to enter
. Enter the first command.
display appears. Enter the
TIMER
TIMER 1 SETUP
TIMER 2 3
, or
4
appears here.