Setting The Date; Backlight - Medion MD 82467 Bedienungsanleitung

Setting the date

SYSTEM SETUP
1. Open
time".
2. Confirm with OK. The
displayed.
3. Use the arrows to select
twice) and confirm with OK.
4. The year flashes. Use the arrows to select
the year and confirm by pressing OK.
5. The month flashes. Use the arrows to select
the month and confirm by pressing OK.
6. The day ("DATE") flashes. Use the arrows to select
the day and confirm by pressing OK.
7. The day ("DAY") flashes. Use the arrows to select
the day of the week and confirm by
pressing OK.
8. The message
returns to

Backlight

The display's backlight comes on each time the button is pressed. The
backlight's factory setting is for 10 seconds. You can switch off the backlight or
extend it to 60 seconds.
Please note that the backlight uses up additional battery life.
1. Keep the SETUP key pressed down for approx. 3
seconds, until
2. Press SETUP again briefly to open
3. Confirm with OK. The
displayed.
Use the arrows (press three times) to select
4.
BACKLIGHT SETUP
the
5. The current set time flashes (factory setting is for
10 seconds). Use the arrows to select
required time span in five second intervals.
In order to switch the backlight off, select "00"
seconds. Confirm with OK.
6. The confirmation message
the display returns to
10
as described in "Setting clock
VOL/MUTE SETUP
the
SUCCESS
appears and the display
CODE SETUP
.
CODE SETUP
appears.
VOL/MUTE SETUP
and confirm with OK.
SUCCESS
CODE SETUP
is
DATE SETUP
(press
SYSTEM SETUP
.
is
the
appears and
.