Programming The Eco Mode - ECM TECHNIKA V Profi PID Bedienungsanleitung

Please take the following steps to program the cleaning reminder:
–
+
at the same time and "t1" will appear on the display.
Press and
–
button until you reach "CLn". Press
Press the
Now you can carry out the programming in steps of 10 (0-200) by pressing
–
. In order to leave the programming mode, wait until "CLn" appears and
and
–
then press the button.
For example, if you have programmed 90, then you will be prompted with a
"CLn" on the display to clean the brew group after 90 brewing cycles.
Clean the brew group in such a manner that the brew group is flushed with at
least 10 brewing cycles until the temperature indication re-appears on the display
(see 7.2 Brew group cleaning).
A single brewing cycle is when the brew group lever is activated for more than 15 seconds.
If you press the brewing lever after "CLn" appears on the display, a counter on
the display counts down from 10 to 1 per brewing lever operation. The
temperature values are then displayed again and the programmed reminder value
is active again.
We recommend cleaning the brew group between about 90 to 140 brewing cycles.

6.3.3 Programming the ECO mode

The ECO mode gives you the option to set an automatic switch off after a preset time. After the last brewing process,
the machine will start a Countdown of the preset time. The countdown will be running in the background. When the
countdown is finished the machine will automatically turn off. To reactivate the machine, move the brew lever into
the upper position and the machine will heat-up again. You can also switch the machine off and on again.
1 Switch on the machine.
–
+
at the same time and "t1" will appear on the display.
2 Press and
–
button until you reach "Eco". Press
3 Press the
Instruction manual TECHNIKA V Profi PID
+
to enter the CLn menu.
+
to enter the Eco menu.
29
+
ENGLISH