Pressure Adjustment - Solo 425 Originalbetriebsanleitung

7. Assembly
The Sprayer is assembled except for the pump lever
which can be attached to either side. (discharge
hose and lever grip already fitted) 1-off lever grip (LX
lever model). The pressure sprayer is supplied with
fittings for assembly of the lever grip (LX lever)
preattached on the left-hand side (facing towards the
tank inscription). If you prefer the lever grip (LX lever)
to be mounted on the opposite side, reposition the
safety clips (a) on the r.h. side.
(schematic diagram / depending on the version)
When fitting the LX lever, the retaining tube (b) of the
LX lever should be facing upwards and back (facing
towards the tank inscription).
If you prefer the lever grip (LX lever) to be mounted
on the opposite side, reposition the safety clips (a)
on the r.h. side.
To store the device, raise the pump handle (C) of the
LX lever in the retaining tube (b) and suspend the
spray tube in both clips (d).
To work the pump handle (c),lower it again in the
retaining tube (b).
The spray tube is connected to the shut-off valve by
means of screw cap.
ENGLISH 4
8. Correct choise of
The spray tube is connected to the shut-off valve by
means of screw cap (e).
For the treatment of shrubs, bushes and trees (three
dimensional distribution) we recommend the use of
the hollow cone nozzle (f) . For area treatment (two
dimensional distribution) we recommend the use of a
flat spray nozzle (g).
For the treatment of tall bushes or trees, a brass tree
lance (150cm length) is available as an accessory
(part no. 49 00528).

9. Pressure adjustment

To regulate the output quantity/ droplet size, the
spray pressure can be adjusted in steps from 1-4 bar.
The pressure is adjusted prior to filling the tank by
turning the adjuster cap (h) on top of the pressure
tank. After any pressure in the pressure tank has
been released via the shutoff valve, press down
adjuster cap and locate the selected pressure marker
tooth over the tooth on the pressure tank.
Should spray pressure in excess of 4 bar be required
we recommend to replace the pressure valve with the
pressure plug (i)(part no. 42 00 215) which is
supplied with the unit. Release any pressure in the
pressure tank first before replacing the valve. A
spanner width of 24 mm is required.