Heater guard rail installation (optional)
Disconnect the power supply on all phases and make
sure that the heater is cooled down.
! Caution! Hot surfaces. Risk of burns by
a hot heater.
1. Lift the ring-shaped top cover
2. Disconnect the connectors for both power sup-
ply lines (open clip and pull off ).
3. Unmount (unscrew) two securing handles (3) on
the outer side of the housing.
4. Remove the heating block by pulling it up out of
the heater.
back side Zeus
30
Note:
The round-shaped guard rail is an optionally availa-
ble accessory. Please bear in mind that you will also
need the set of mounting brackets as well to install
the guard rail.
4.
4.
3.
3.
2.
EN
1.
1.
2.
2.