Replacement Of Heating Elements - EOS Zeus series Montage- Und Gebrauchsanweisungen

Replacement of heating elements

1. Remove stones from the rock store.
2. Loosen 4 securing screws (1) in the base
plate of the heating block.
3. Lift up and take off the decoration ring (2).
4. Disconnect the plugs of the power supply
cables on the bottom of the heater through
the side opening.
5. Lift up the heating block (3) and take it out
of the heater
6. Loosen two screw of the terminal box cover
(bottom side) and take this panel off.
7. The heating elements are fitted in the base
plate and secured underneath it with nuts
with fan-shaped washers.
8. Pull off the inner wiring from the heating
element terminals and loosen the moun-
ting nut. Take the heating element out. In-
stall the new element in the reverse order
and connect it.
! Make sure that the spade terminals of
the inner wiring are tightly fitted on the hea-
ting elements and the wire ends are tightened
in the screw connections!
9. Mount the cover panel of the terminal box
back in position and secure it with 2 screws.
10. Set the heating element block back into the
housing and secure it with 4 screws.
11. Set the decoration ring back on top and fill
the stones into the rock store.
12. Connect the power supply cables.
! Notice:
Use sauna stones with the size 100/150 mm.
Make sure to observe the advice for sauna
rocks on the next page.
32
View from top
3.
4.
Access to cable
connectors
EN
2.
1.