Operating Modes; Displays - Sentiotec A3 Montage- Und Gebrauchsanweisung

1

Operating modes

You have two operating modes: sauna and steam operation.
You can start the operating modes directly via the Quick-Start feature (refer to chapter 6 and 7) or after the set desired
time has elapsed - time until the stove turns on (refer to chapter 8 and 9).
During sauna operation you will have dry heat at your disposal. The temperature is high, the humidity is low.
During steam operation the temperature in the sauna cabin will be lower, but the relative humidity will be significantly higher.
Steam operation at temperatures up to approx. 65°C only:
If you adjust the steam using the knob 7 while the temperature is above 65°C, the display 3 will indicate the message: Hot
• The control will shut down the heater.
• The steam generator will be switched on once the temperature falls below 65°C.
With a fan the cabin can be vented in any operating mode (see chapter 10) .
A final cabin drying program (see chapter 11) will start automatically as soon as steam operation has stopped. It will
switch off as soon as drying is completed.
2

Displays

Self-testing of the control (display flashes).
Heater is running.
Steam generator is running.
Fan is running.
Fan is running -100 % capacity
No display =
heater, steam generator and fan not running.
Final drying program running.
Door of the sauna cabin is open.
(applies to optional sauna door safety-monitor only).
Excessive temperature for running the steam generator (more than 65°C).
Low-water level in steam generator
(applies to units with a connection to a water-shortage indicator only).
WE DO IT FIRST.
Instructions for use for the user
Figure 6
P. 8/20