Appliance-Specific Safety Instructions For Grinders; Before Use; Fitting The Connector Nipple; Assembly/Disassembly Of The Polishing Disc - Parkside PDAP 75 A1 Originalbetriebsanleitung

■ If universal rotary joints (claw couplings) are
used, locking pins must be used to provide pro-
tection; Whipcheck® air hose restraints must be
used to provide protection in case of a failure of
the connection of the hose to the machine.
■ Ensure that the maximum permissible pressure
on the machine is not exceeded.
■ Never carry pneumatic machines by the hose.
Appliance-specific safety instructions
for grinders
WARNING!
■ Dusts from materials such as leaded paint,
some types of wood and metal can be
harmful to your health.
■ Contact with or inhalation of these dusts can
represent a health hazard for the person
operating the appliance and other people in
the vicinity.
■ Wear safety goggles and a protective dust
mask!

Before use

NOTE
► The compressed air polisher may only be op-
erated on cleaned, oil-atomised compressed
air and may not exceed the maximum operat-
ing pressure of 6.3 bar on the appliance.
The compressor must be fitted with a pressure
reducer to regulate the working pressure.
► Wind the Teflon tape
threaded connectors.

Fitting the connector nipple

♦ Wrap the threads on the connector nipple
with the supplied Teflon tape
♦ Screw the connector nipple
inlet .
PDAP 75 A1
supplied around all
.
into the air
Assembly/disassembly of the
polishing disc
♦ Screw the polishing disc
screw thread .
♦ To remove the polishing disc
thread with the assembly spanner
unscrew the polishing disc
of the thread .

Fitting the polishing attachments

CAUTION!
► Ensure that the appliance is disconnected
from the compressed air source before you fit
or remove a polishing attachment
♦ The polishing disc
ing attachments
matching Velcro attachments.
♦ Select the polishing hood
polishing and press it onto the polishing disc
Ensure that it is centred.
♦ Now select the polishing hood
final polishing and press it onto the polishing
disc .
Ensure that it is centred.
♦ For the final finish, select the fake fur attachment
and press it onto the polishing disc
Ensure that it is centred.
♦ To change the attachment, lift one side of the
polishing attachment
the polishing disc
clockwise onto the
, immobilise the
and
anticlockwise out
,
and the supplied polish-
, , are equipped with
(orange) for pre-
(black) for
.
, , and pull it off
.
GB │ IE │ NI │
, .
.
7 ■