Interrupting Operation; Ending Operation; Using Detergents; Fixing The Wheels - Parkside PHD 100 E2 Originalbetriebsanleitung

3. Connect the supply hose to the equip-
ment with the aid of the quick connec-
tion for the garden hose adapter (9).
4. Fully open the water tap.
Bleed the equipment:
5. Switch on the equipment at the on/off
switch (5) until the pressure has built
up.
6. Switch off the equipment at the on/off
switch (5).
7. Depress the start lever on the spray
gun (10) until the pressure is released.
8. Please repeat steps 5. to 7. several
times until there is no further air in the
equipment.

Interrupting operation

• Release the lever of the gun (
• During prolonged work intervals turn
off the washer by its ON / OFF switch
A
( 5).

Ending operation

• After working with cleaning agents,
run the equipment with clean water to
completely rinse the cleaning agent
from the pipes.
• Release the lever of the gun (
• Turn off the pressure by its ON / OFF
A
switch ( 5).
• Turn off the water tap.
• Pull the lever of the gun (
the pressure existing within the system.
• Pull the mains plug and wind up the
mains cable.
• Disconnect the pressure washer from
the water mains.

Using detergents

The washer was designed for operation
with a neutral detergent based on a bio-
logically decomposable anionic tenside.
Other detergents or chemical substances
could impair the safety of the washer and
damage it.
F
Both of the front wheels can be fastened
in order to prevent the unintentional rolling
away of the pressure washer.
•
•
A
10).
Cleaning and
Maintenance

Cleaning

A
10).
A
10) to vent
Always keep the washer clean. Do
not use any detergents or solvents.
•

Fixing the Wheels

To do so, press both bolts (16) down-
wards. The wheels are now no longer
able to turn.
To cancel the wheel fixing, push the
two bolts (16) upwards.
Pull out the power plug before
every maintenance operation. There
is a risk of electrocution or of injury
from moving parts.
Never direct the water jet
against the washer, nor clean
the washer under flowing
water. This could give rise to
the danger of electric shock
and damage the washer! .
Always keep the ventilation slots clean
and free.
MT
GB
49