Herunterladen Inhalt Inhalt Diese Seite drucken

Charging Process - Parkside PSSA 3.6 C3 Originalbetriebsanleitung

Vorschau ausblenden Andere Handbücher für PSSA 3.6 C3:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 55
lack of experience and knowl-
edge if they have been given
supervision or instruction con-
cerning use of the appliance in
a safe way and understand the
hazards involved. Children shall
not play with the appliance.
Do not use the charger to
b)
charge non-rechargeable batter-
ies.
c) To charge the battery, use only
the charger supplied. Risk of fire
and explosion. This ensures that the
safety of the device is maintained.
d) Before each use, check the
charger, cable and plug and
have them repaired by quali-
fied professionals and only with
original parts. Do not use a de-
fective charger and do not open
it up yourself. This ensures that the
safety of the device is maintained.
e) Connect the charger only to a
socket with an earth. Ensure
that the mains voltage matches
the specifications on the charger
rating plate. Risk of electric shock.
f) Disconnect the charger from the
mains before closing or open-
ing connection to the battery /
power tool / device. This ensures
that the battery and charger are not
damaged.
g) Keep the charger clean and
away from wet and rain. Do not
use the charger outdoors. Dirt
and the entry of water increase the risk
of electric shock.
h) Operate the charger only with
the appropriate original bat-
teries. Charging other batteries may
result in injuries and risk of fire.
i)
Avoid mechanical damage to
the charger. This can result in inter-
nal short circuits.
j)
Do not operate the charger on a
combustible surface (e.g. paper,
textiles). Risk of fire due to heating
during charging.
k) In order to minimise the risk of
electric shock, pull the charger
plug out of the socket prior to
cleaning it.
l)
If the power cable for this equip-
ment is damaged, it must be
replaced by the manufacturer,
a customer service agent of the
same or a similarly qualified per-
son in order to prevent hazards.

Charging process

Do not expose the battery to
extreme conditions such as
heat and impact. There is a
risk of injury from leaking
electrolyte solution! In case
of contact, rinse with water
or neutraliser and consult a
doctor if contact has occurred
with eyes etc.
Charge the battery only in dry
areas.
There is a risk of injury from
electric shock.
Ensure that the equipment is charged
for no longer than 3 hours without
interruption. The battery and equip-
ment could be damaged and they
consume energy unnecessarily in
case of longer charging time. Over-
charging invalidates the guarantee.
The device may only be powered with
SELV (Safety Extra Low Voltage) as
marked on the device.
GB
MT
49

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis