Canton Smart Soundbox 3 Bedienungsanleitung Seite 85

Problem Possible cause
Playback of the The automatic playback function Autoplay [APL] is
Bluetooth device starts activated [ON].
®
automatically when the
speaker is switched on.
Coupling of wireless 1. The slave speaker was not disconnected or was
speakers fails. not disconnected from the mains long enough
before pairing.
2. The slave speaker was in standby mode
during the pairing.
3. The slave was connected to the mains before
the coupling was initialised on the Soundbox
(master speaker).
4. The distance between slave and Soundbox
is too high.
The Soundbox 3 does 1. The signal at the [AUX] (Line) input is too low.
not change inputs
automatically
Solution
Set the Autoplay [APL] function to [OFF].
1. Disconnect the slave speaker to be paired for
at least 30 seconds from the mains.
2. After turning on the power switch of the slave speaker
respectively connecting it to the mains, power it up by
the Power " " key.
3. Always start pairing at the Soundbox before connecting the
slave to the mains.
4. Reduce the distance between Soundbox and slave speaker.
The maximum distance is 10 m in the same room.
1. Increase the output level on your source device.
English
3 8 5