Bt Select [Bts] - Canton Smart Soundbox 3 Bedienungsanleitung

To change the way in which the paring process is initiated, proceed as follows:
To enter the Menu, press and hold the input select key "
1
Use the "+" or "-" button to navigate into the menu Wireless Setup [WIS] and confirm with the Play/Pause button " ".
2
Select the function Bluetooth
3
Select the item Pairing Mode [BTP] and confirm with the Play/Pause button " ".
4
Use the "+" or "-" key to select the desired parameter [MAN] or [AUT].
5
[AUT] = The device sends the pairing request permanently (automatic mode).
[MAN] = The request is activated by pressing the "Bluetooth Pairing" button only on the optional remote control.
Press the input select key "
6
Notes: • If a signal is being transmitted via Bluetooth wireless technology, the Soundbox 3 does not send a pairing request to a second
mobile device, even if the automatic mode [AUT] is selected.
• If the input [BT] is not selected, neither automatic nor manual pairing is possible. To achieve pairing independent of the
selected input, the BT Select [BTS] function must be set to [AUT]. Please refer to the next chapter.
• The requirements for a successful pairing process are indicated in the chapter "Playback via Bluetooth® wireless technology".

BT Select [BTS]

When this function is enabled [AUT], the speaker automatically switches to the input [BT] whenever it detects an audio signal from a
(mobile) device. If this function is deactivated [MAN], the input must be selected manually.
To activate / deactivate this function, proceed as follows:
To enter the Menu, press and hold the input select key "
1
Use the "+" or "-" button to navigate into the menu
2
Select the function Bluetooth
3
Select the item BT Select [BTS]
4
Use the "+" or "-" key to select the desired parameter [MAN] or [AUT].
5
Press the input select key "
6
Note: Depending on the (mobile) device used, the speaker may also switch to the input [BT] when a message is typed or other
system tones are received when the automatic mode [AUT] is activated. A time delay of 5 seconds is programmed to avoid
continuous switching (e.g. on arrival of a message).
Note: If the BT Select function is activated [AUT], the input [BT] cannot be selected via the Input "
In this mode, the speaker can be paired with the (mobile) device anytime, regardless of the selected signal input.
" for at least 3 seconds
Setup [BT] and confirm with the Play/Pause button " ".
®
" to exit this menu item.
" for at least 3 seconds.
Wireless Setup [WIS]
Setup [BT] and confirm with the Play/Pause button "
®
and confirm with the Play/Pause button "
" to exit this menu item.
and confirm with the Play/Pause button " ".
".
".
" key any longer.
English
3 7 7