Troubleshooting - Abicor Binzel MT 452 W Betriebsanleitung

MT/AUT/AUT RAB

10 Troubleshooting

DANGER
Risk of injury and machine damage when handled by unauthorized persons
Incorrect repair work and changes of the product may lead to significant injuries and
damage to the device. The product warranty will be rendered invalid if work is carried out on
the product by unauthorized persons.
• Operating, maintenance, cleaning and repair work may be carried out only by qualified
personnel (in Germany see TRBS 1203).
DANGER
Risk of burns
Risk of burns from hot coolant and hot surfaces.
• Switch off the coolant recirculator before starting maintenance, servicing, assembly,
disassembly or repair work.
• Allow the welding torches to cool down.
• Wear the correct protective gloves.
Please observe the attached 'Warranty' document. In the event of any doubts and/or problems,
please contact your retailer or the manufacturer.
NOTICE
• Please also consult the operating instructions for the welding components, such as the
power supply, welding torch system, re-circulating cooling unit, etc.
Problem Cause
Torch becomes to • Contact tip / Tip adapter loose
hot
• Power connections loose on the torch
• Coolant flow to low
Wire burned solid • Wrong parameters set
in the contact tip
• Worn-out contact tip
• Adjust wire burn-back function
Tab. 11
Troubleshooting
BAL.0193.0 • 2018-07-31
side and toward the work-piece
10 Troubleshooting
Solution
• Check and tighten
• Check and tighten
• Check cooling system, increase
coolant flow
• Check or correct setting
• Replace
• Correct
EN - 19