Faults And Troubleshooting - Abicor Binzel ABICAR 1200 PRO 42V Originalbetriebsanleitung

ABICAR 1200 PRO 42V

10 Faults and troubleshooting

► Observe the documentation for the welding components.
► If you have any questions or problems, consult an appropriate specialist retailer.
Tab. 8
Faults and troubleshooting
Fault
Device cannot be switched on.
The mains supply light is off.
Guide rollers do not rotate.
Wheel rotates eccentrically.
The limit switch is not responding.
The screen is black after
switching on.
There is an error on the display.
Values cannot be read.
The following messages are shown
on the display:
The following messages are shown
on the display:
The following message is shown
on the display:
The following message is shown
on the display:
Cause
Device has no power.
Leads/drive belt have become loose or
motor is blocked.
The guide roller is defective.
Guide rollers dirty.
The wheel is not correctly fastened.
The wheel is dirty.
The limit switch is defective.
Connection cable, power device or control
device is defective.
The display or the power device is
damaged.
The limit switch was triggered.
There is an obstacle in front of the device.
The limit switch was triggered.
There is an obstacle in front of the device.
Switching between travel directions was
too fast.
When switching on, the travel direction
switch is not set to "O".
If the message is displayed during
operation, then the device is damaged.
10 Faults and troubleshooting
Troubleshooting
► Inspect the connection cable and plug it
in correctly if necessary.
► Consult your specialist dealer or the
manufacturer.
► Replace guide rollers.
► Clean guide rollers.
► Properly retighten screw for wheel
attachment.
► Clean or replace wheel.
► Consult your specialist dealer or
the manufacturer.
► Consult your specialist dealer or
the manufacturer.
► Consult your specialist dealer or
the manufacturer.
► Set the travel direction switch to the "O"
position.
► Remove obstacles.
► Set the travel direction switch to the "O"
position.
► Remove obstacles.
► Set the travel direction switch to the "O"
position.
► Set the travel direction switch to the "O"
position.
► Consult your specialist dealer or the
manufacturer.
EN - 27