Ottobock 4R88 Gebrauchsanweisung Seite 9

Screws are available in the following sizes:
Article no.
506G3=M8×14
506G3=M8×16
Use a 710D4 Torque Wrench to tighten screws.
Attention!
For trial fitting: Tighten the 506G3 Set Screws clockwise to 10 Nm
(7.4 lb / ft, 88 lb / in).
For completion: Secure the 506G3 Set Screws with 636K13 Loctite
and pre-tighten them clockwise to 10 Nm (7.4 lb / ft, 88 lb / in);
then complete assembly by tightening them to 15 Nm ( 11 lb / ft ,
133 lb/in).
3 Technical data
Article no.
Weight
System height
Material
Max. patient weight
Mobility grade
4 Handling
The translation direction is determined by the position of the sliding adapter
on the modular tube – in most cases this will be the frontal plane.
The upper section of the adapter may be slid ± 11 mm over the stable
dovetail guide and subsequently secured by the 501Z16 Locking Bolts
(Fig. 1, item 3).
Torque moment: 15 Nm (11 lbf.ft., 133 lbf.in.).
Use the 710D4 Torque Wrench.
Secure the adjustment screws in their final adjustment position using
636K13 Loctite.
Length
14 mm
16 mm
4R88
185 g
51 mm
Titanium
100 kg
–
Ottobock | 9