Servo Mode; Setting Servo Flash Mode; Pre-Flash Suppression Or Synchronisation Settings - Metz mecablitz 64 AF-1 digital Bedienungsanleitung

10.4 SERVO mode

SERVO mode is a simple slave mode without
or with complete pre-flash suppression in
which the slave flash unit always triggers
a flash as soon as the camera flash unit
receives a light pulse.
In SERVO mode, only manual flash mode is
possible. Manual flash mode is automatically
activated after switching to SERVO mode.

10.4.1 Setting SERVO flash mode

• Set the camera to TTL mode.
TTL
• Press the sensor button of the displayed
0.6- 7.2 m
M-
5,6
m
35
Zoom F
m
EV
k
O
MODE
• Press the
REMOTE SLAVE
• Press the
SERVO
The mode of operation is adopted.
p
q
If desired, partial light output can be set,
see 10.4.3.
SYNC
M-Servo
M-
m
Zoom 35
m
P
1/1
194
mode of operation on the touch display as
many times as it takes for the display for
selecting the mode of operation to appear.
sensor buttons on the
SERVO
touch display and select
SERVO
sensor button on the
touch display.
SYNC
M-Servo
M-
m
Zoom 35
m
P
1/1
SYNC
LEARN
.
10.4.2 Pre-flash suppression or
synchronisation settings
• Set the camera to TTL mode.
• Press the sensor button
display as many times as it takes for the
display for selecting the type of synchroni-
sation.
• Press the sensor button on the touch
O
display:
synchronisation without pre-flash
synchronisation with pre-flash
The synchronisation of operation is adopted.
If the synchronisation set here does not work
properly, then proceed as described in
10.4.4.
SYNC
on the touch