Servo Mode; Slave Mode - Metz 58 AF-1 digital Bedienungsanleitung

18.5 Servo mode

The Servo mode is a simple slave mode in which the slave flash unit always
triggers a flash as soon as it receives a light pulse.
Adjustment procedure for servo flash mode
• Select a mode for the camera flash unit without pre-
BEEP
Select
flash.
Remote
• Press the
FB
on the display.
Set
• Use the
"Remote". The selected menu item will be highlighted
with a dark bar.
Servo
• Press the
Set sing the
effect immediately.
• Press the button
returns to the normal display. If the button
Servo
pressed, the screen will automatically return to nor-
MZoom 35
mal display after 5 s.
P1/1
Para Sel
In general, only the manual flash mode
in the SERVO flash mode.
This is automatically selected after switching the
SERVO flash mode on.
key repeatedly until "Select" appears
Sel
and keys to select the menu item
button and select "Servo" by pres-
Set
and buttons. The setting will take
repeatedly until the screen
M
is possible
Setting partial lighting or reflector position (MZoom)
• In SERVO mode, press the
until the set partial lighting or reflector position is
shown. By using the
tial lighting (for example 1/8) or reflector position
(for example MZoom 50) can be set.
Wait for all of the flash units involved to become flash-ready.
Once the slave flash unit is flash-ready, its AF measuring beam
king.
Slave groups and remote channels cannot be set in SERVO mode.
Switching Servo flash mode off
• Press repeatedly until "REMOTE" is shown in
Sel
the screen
• Press the button and by using the
Set
select the menu item "REMOTE OFF". The selected
menu item will be highlighted with a dark bar. The
setting will take effect immediately.
• Press the button repeatedly until the screen
is not
returns to the normal display. If the button
pressed, the screen will automatically return to nor-
mal display after 5 s.
button repeatedly
Para
+ –
and buttons, the par-
button,
is not
Servo
MZoom 35
P1/64
Para Sel
will start blin-
BEEP
Select
Remote
FB
Set
Remote
OFF
Set
123