Flash Synchronisation; Servo Mode - Metz mecastudio TL-300 Bedienungsanleitung

7 Flash synchronisation

The studio flash unit can be operated in three
different synchronisation modes:
1.Servo mode, triggered by the camera's own
flash
- without pre-flash.
- with pre-flash (e.g. red-eye function).
- Learn mode.
2.Mode with a synchronous cable.
3.Mode with a radio module (accessory).

7.1 Servo mode

Servo mode is a simple slave mode without
or with complete pre-flash suppression in
which the studio flash unit bl on triggers
a flash as soon as the camera flash unit
receives a light pulse.
Use an infrared clamp (accessory) if the
camera's own flash works as a controller, and
hence does not contribute to the illumination
of the motif.
Slip the infrared clamp over the camera's
own flash. The infrared part of the flash now
controls the studio flash unit.
Setting SERVO flash mode
• Press power switch
unit so that it is in position (ON).
• Press the button
Sync
• Press the sensor button
Synchronisation menu.
Servo
• Press the sensor button
select Synchronisation:
- Servo (without pre-flash)
- Servo
Sync. Cord
Servo • Press the release button on the camera
Servo
so that the camera's own flash unit is
Learn
activated. The studio flash unit triggers a
flash as soon as it receives a light impulse.
+
If no pre-flash is detected in learning mode,
then the studio flash unit enters 1 automati-
cally and synchronises with the 1st flash of
the camera's own flash unit.
of the studio flash
D
and open the menu.
open the
or and
(with pre-flash)
87
k