Automatic Flash Mode; Strobe Flash Mode - Metz mecablitz 64 AF-1 digital Bedienungsanleitung

7.6 Automatic flash mode

In the automatic flash mode
unit sensor
reflects back from the subject. The sensor
has a coverage of about 25°, and only
measures the light for the time a flash is fired
by the mecablitz. The flash is cut off as soon
as sufficient light has been emitted for
correct exposure. The sensor
mecablitz has to be directed at the subject.
Setting the mode of operation
• Switch on the flash unit with the
M
button.
The start screen appears.
Thereafter, the flash unit always switches
7.2 m
on with the mode of operation that was
M-
5,6 used last.
m
35
F
Zoom
m
P
• Press the sensor button of the displayed
1/1
mode of operation on the touch display as
many times as it takes for the display for
O
MODE
selecting the mode of operation to appear.
TTL
A
• Press the
M
touch display and select
p
• Press the
q
display.
• Set a suitable mode of operation on the
A
camera, e.g.
• Tap the shutter release to transfer data
0.6- 7.2 m
between the flash unit and the camera.
M-
5,6
m
35
Zoom F
m
EV
A
, the flash
measures the light that
of the
sensor buttons on the
A
.
A
sensor button on the touch
A
.

7.7 Strobe flash mode

The strobe flash mode is a manual flash
mode. It allows several flash exposures to
be made on a single photo, which can be
especially interesting for movement studies
or special effect images. In strobe flash
mode, several flashes at a certain flash
frequency are emitted. For this reason, this
function is only possible with a partial light
output of 1/8 or less.
For a strobe exposure, the frequency of the
flashes (flashes per second) as well as the
number of flashes must be selected.
Strobe number of flashes (N)
In strobe mode, the number of flashes per
shot (N) can be selected.
The number of flashes can be set from 2 to
90. The maximum manual partial light output
is automatically adjusted to this number.
+
The maximum possible number of flashes
(N) depends on the set partial light output
(P).
k
181