Manual Flash Mode - Metz mecablitz 64 AF-1 digital Bedienungsanleitung

In these cases, the normal TTL flash mode
TTL

7.3 Manual flash mode

In the manual flash mode M , the flash unit
emits the full uncontrolled amount of light if
no partial light output has been selected.
The specific photographic situation can be
taken into account by adjusting the aperture
setting or by selecting a suitable manual
partial light setting.
The setting area ranges from
P 1/1 - P1/256 in
P 1/1 - P 1/64 in
The display shows the distance at which the
subject is correctly lit (see 5.2).
Setting the mode of operation
• Switch on the flash unit with the
TTL
k
0.6- 7.2 m
M-
5,6
m
35
Zoom F
m
EV
TTL
• Press the sensor button of the displayed
0.6- 7.2 m
M-
5,6
m
35
Zoom F
m
EV
178
-will be set.
M
mode and
M HSS
mode.
button.
The start screen appears.
Thereafter, the flash unit always switches
on with the mode of operation that was
used last.
mode of operation on the touch display as
many times as it takes for the display for
selecting the mode of operation to appear.
O
• Press the
MODE
touch display and select
A
M
• Press the
GN
display.
p
q
• Set a suitable mode of operation on the
camera, e.g.
M
7.2 m
M-
• Tap the shutter release to transfer data
5,6
m
35
Zoom F
m
between the flash unit and the camera.
P
1/1
+
Various cameras support manual flash mode
M only in the camera's M mode (manual).
In other camera models, an error message
appears in the display and the release is
locked.
sensor buttons on the
M
.
M
sensor button on the touch
M
.