Remote Channel Settings; Remote Slave Flash Mode - Metz mecablitz 64 AF-1 digital Bedienungsanleitung

10.1.4 Remote channel settings

There are four independent remote channels
to use so that multiple remote systems in the
same room do not interfere with one another.
Master and Slave flash units belonging to the
same remote system must be set to the same
remote channel.
• Press the
for the selection menu to appear.
• Press the
touch display.
PARAMETER
PARAMETER O
• Press the
touch display.
ZOOM
CHANNEL
• Press the
touch display and select a remote channel,
O
CHANNEL
CHANNEL 2
e.g.
• Press the sensor buttons on the touch
CHANNEL 1
display e.g.
CHANNEL 2
selected.
CHANNEL 3
p
q
The setting will take effect immediately.
The channel setting can be checked by
pressing the sensor button
D
button as often as it takes
PARAMETER
sensor button on the
CHANNEL
sensor button on the
sensor buttons on the
.
CHANNEL 2
for the channel
i
.

10.2 Remote slave flash mode

The flash unit supports the wireless Nikon
remote system in slave flash mode and is
compatible with the Nikon system „Advanced
Wireless Lighting". At the same time, one
or more slave flash units can be remotely
controlled from one master flash unit on the
camera (e.g. mecablitz 64AF-1 digital).
A slave flash unit can be assigned to one of
three possible slave groups (GROUP A, B or
C). The master flash unit can control all of
these slave groups simultaneously and at the
same time take the settings for each slave
group into account.
So that multiple remote systems in the same
room do not interfere with one another, there
are four independent remote channels avai-
lable (CH 1, 2, 3 or 4).
Master and slave flash units belonging to the
same remote system must be set to the same
remote channel.
The slave flash units must be able to receive
the light from the master flash unit with the
integrated sensors for the remote mode.
Depending on the camera model, the
camera's internal flash unit can also
function as master flash unit.
k
191