Manual Flash Mode - Metz mecablitz 44AF-2 digital Bedienungsanleitung

Exposure correction through alteration
of the lens aperture is not possible, as
the camera's automatic exposure views
the altered aperture as the normal wor-
king one.
Manual flash exposure correction in
TTL flash modes can only take place if
the camera supports this feature (see
camera operating instructions).
Don't forget to delete the TTL exposure
correction on the camera after the shot.
Highly reflective objects in the inten-
ded shot can disturb the camera's
automatic exposure. This results in
underexposure. Remove reflective
objects or set a positive correction
value.

5.2 Manual flash mode

In manual flash mode M, full flash out-
put is deployed if no partial lighting is
set.
By selecting a suitable partial light out-
put or adjusting the camera's aperture,
it is possible to adapt to the ambient
situation.
+
The adjustable range stretches from
P 1/1 — P1/32.
Configuration procedure
• Switch on the flash unit by pressing
the button
+
• Press "M"
ting mode M .
Manual partial light output
Partial light output can be configured in
manual operating mode M.
Configuration procedure
+
• Press the "M" b button on the flash
unit until the LED illuminates the
desired partial light output 1/1, 1/2,
1/8 or 1/32.
The setting is effective immediately
and saved automatically.
Various camera types only support
manual flash adjustment in manual M
camera operating mode.
.
to set the manual opera-
SL
M
TTL LED
1/1 1/2 1/8 1/32
SL
M
TTL LED
k
+
113