Automatic Flash Mode; Manual Flash Mode - Metz 58 AF-1 digital Bedienungsanleitung

Setting procedure:
TTL HSS
Mode
• Press the
A A
M
LC display.
Set
• Set the flash mode
keys. The flash mode selected is then highlighted.
The setting takes effect immediately.
A
• Press the button
AZoom 70
the normal view. If the button
11 m
display will change back to the normal view after
Mode Para Sel
about 5 seconds.
If the shot was properly lit, the correct exposure indica-
tion will flash „OK" for about 3 seconds (see 13).

5.5 Automatic flash mode

When shooting in automatic fill-in flash mode in daylight, the automatic flash
A
mode will automatically set a correction of between -1 and -2 f-stops to
compensate for flash exposures (see 6.3 and 10.5).
This has a graduated lightening effect on shadowy areas, which has a natural
appearance on the photograph.

5.6 Manual flash mode

M
In the manual flash mode , the flash unit emits the full uncontrolled amount
of light if no partial light output has been selected. The specific photographic
situation can be taken into account by making adjustments to the aperture set-
ting or by selecting a suitable partial light setting.
104
Mode button until „Mode" flashes on the
A
using the and
to change the LC display back to
is not pressed, the
Setting procedure:
• Press the Mode button until „Mode" flashes on the
LC display.
M
• Choose the flash mode using the
arrows. The flash mode M is then highlighted.
The setting takes effect immediately.
• Press the button to change the LC display back to
the normal view. If the button
display will change back to the normal view after
about 5 seconds.
Set partial light output:
• Press the Para button until „P" flashes on the
LC display for partial light output.
• Set the desired light output (1/1-1/256) with the
+
–
or buttons.
The setting takes effect immediately.
• Press the button to change the LC display back to
the normal view. If the button
display will change back to the normal view after about 5 seconds.
The mecablitz LC display will indicate the flash-to-subject distance required for a
correct flash exposure.
Some cameras only support the
camera is set to the manual operating mode M.
A
Mode
M
M
MHSS
and
M
is not pressed, the
MZoom 35
11 m
Mode Para
F 4.0
M
MZoom 35
4,1 m P1/8
Para
is not pressed, the
M
manual flash mode when the
Set
Sel
+
–