Connecting The Controller - Omnitronic TMC-1 MK2 Bedienungsanleitung

6. CONNECTING THE CONTROLLER

1
Set up the controller on a plane, stable ground.
2
Set the power selector switch to the position [USB] for power supply via the USB connection of the
computer.
3
Use the supplied USB cable to connect the controller to an available USB port on your computer.

Connect the controller directly to a USB 2.0 port in order to achieve the fastest transfer rates and an
optimum performance.

As soon as the controller is connected to a computer, it will be
recognized as a standard USB HID (Human Interface Device)
device and the required drivers are installed. Windows will display
a notification informing you that the hardware was successfully
installed.
The [POWER] indicator lights up red to indicate that the controller is receiving power from the USB bus.


The controller can be used in conjunction with your computer's soundcard without causing conflicts.
You may connect and disconnect the controller at any time, although not when the Virtual DJ software
is in use.
4
The controller is supplied with power via the USB connection of the computer. However, if the
connection should not supply sufficient power (e.g. when connected to a non-powered USB hub), use
the supplied power unit: Connect the cable of the power unit to the power input [DC IN 5V/1A] and the
power unit to a power outlet. Set the power selector switch to the position [ADAPTOR].

Use the unit only with the supplied power unit. Always disconnect the mains connector when you wish
to change connections, move the unit to a different place or if it is not used for a longer period.
5
After connecting, start the DJ software Virtual DJ LE. If the program has already been started prior to
the connection, it must be terminated and restarted, otherwise the controller cannot be operated.
6
For operation with Virtual DJ, the controller switches to HID mode. To reset the controller to MIDI mode
for use with a MIDI application, switch the controller off and on again after a few seconds.
50/66 00061966.DOC, Version 1.1