Omnitronic TMC-1 MK2 Bedienungsanleitung Seite 52

7.2 Configuration using two sound cards
1
In this case, select [HEADPHONES] in control panel [Outputs]. The two output channels [Master: First
card] and [Headphones: Second card] will be available. If required, you can swap the output routing in
the adjacent drop-down panel.
2
In control panel [Sound card], select [2 CARDS] and in the adjacent drop-down panel, select your
sound cards.
7.3 Configuration using one output
1
In control panel [Outputs], select [HEADPHONES]. The two output channels [Master: Left chan] and
[Headphones: Right chan] will be available. If required, you can swap the output routing in the
adjacent drop-down panel.
2
In control panel [Sound card], select [MONO SEPARATED] and in the adjacent drop-down panel,
select your sound card.

Note
Please refer to the software's audio setup guide for further setup examples.

If your computer is only equipped with a
stereo sound card, you cannot carry out
headphone monitoring. This applies to
most Windows
desktop and laptop computers. If you have
such a computer you can use an
inexpensive external USB sound card for
headphone monitoring.
As an alternative to a second sound card,
a 3.5 mm mono jack Y-splitter may be
used. Then two mono output channels will
be available. This configuration is most
applicable when using standard computer
speakers, however, not when connecting
to a PA system or an external mixer.
52/66
USB sound card
notebooks and
3.5 mm mono jack
splitter
00061966.DOC, Version 1.1
Mac