Cocraft LXC AG18 Bedienungsanleitung Seite 7

Kickback and related warnings
Kickback is a sudden reaction to a wedged or stuck wheel, backing plate, wire brush,
or some other accessory. A jammed or stuck rotating accessory results in the power
tool thrusting violently in the opposite direction of the accessory's rotation at the point
of binding.
For example, if a grinding disc gets stuck or is jammed into the workpiece, the edge
of the disc can grab onto the workpiece and either dig itself down deeper or
kick upwards. The grinding wheel is either thrown towards or away from the user
depending on the rotation of the grinding wheel. The grinding wheel can also break
under these circumstances.
Kickbacks are the result of the power tool being used in an incorrect manner, on
incorrect objects, or under incorrect conditions and can be avoided by observing
the following precautions.
a) Hold the power tool steady and position your arms and body so that you can
adequately handle any kickback. Always use the auxiliary (side) handle if there
is one for maximum control during kickback and to be able to control the torque
"kick" produced by turning the angle grinder on. Kickbacks or reactions to torque
can be controlled by the user if the necessary safety precautions are followed.
b) Never place your hand near the rotating accessory. The accessory can be thrown
back onto your hand.
c) Do not stand in the area in which the power tool could possibly end up if it were
to kick back. Kickback will propel the tool in the opposite direction of the grinding
wheel's rotation at the point of snagging.
d) Be extra careful when working on corners, sharp edges, etc. Avoid bouncing and
getting the accessory stuck. Corners, sharp edges, and bouncing have a tendency
to get the rotating accessory stuck and lead to loss of control of the tool.
e) Never fit a circular saw wood cutting blade or other toothed saw blade.
Such blades frequently lead to kickbacks and loss of control.
Specific safety precautions for grinding and cutting with
a cutting wheel
a) Only use those types of disc/wheel which are recommended for the power tool
and a special shatter guard plate designed for the selected cutting wheel.
Wheels which are not designed for use with the power tool cannot be properly
guarded and can be dangerous.
b) The shatter guard must be fitted to the power tool correctly and adjusted to
provide maximum safety so that the user is exposed to as little of the disc/wheel
as possible. The shatter guard helps to protect the user from shards of shattered
wheel and unintentional contact with the wheel.
c) The wheels/discs must only be used for the recommended work task.
For example: Do not grind with the side of a cutting wheel. Cutting wheels are
intended for cutting using the edge. If force is exerted on the face, they can break.
7