Cocraft LXC AG18 Bedienungsanleitung Seite 12

Operating instructions
Important: Always remove the battery from the power tool before adjusting,
servicing or repairing it.
Fitting a cutting/grinding disc or other accessory
Note: It is important that you select the correct type of disc. Only use cutting discs
for cutting (Fig 1 below) and grinding discs for grinding (Fig 2 below).
Use only Ø 115 mm cutting discs and
grinding discs with 22 mm centre bores.
1. Remove the outer flange by pressing
in the spindle lock and undoing it with
the spanner.
2. Fit a grinding disc or other accessory
onto the inner flange, making sure that
it is properly centred and flat against
the inner flange.
3. Screw the outer flange back on. Hold
down the spindle lock and tighten
the flange using the included spanner.
4. Release the spindle lock and make sure
that the grinding disc/accessory can
rotate freely.
Fig 1
12
Fig 2