Cocraft LXC AG18 Bedienungsanleitung Seite 5

5) Battery tool use and care
a) Recharge only with the charger specified by the manufacturer. A charger that
is suitable for one type of battery pack may create a risk of fire when used with
another battery pack.
b) Use power tools only with specifically designated battery packs. Use of any
other battery packs may create a risk of injury and fire.
c) When battery pack is not in use, keep it away from other metal objects, like
paper clips, coins, keys, nails, screws or other small metal objects, that can
make a connection from one terminal to another. Shorting the battery terminals
together may cause burns or a fire.
d) Under abusive conditions, liquid may be ejected from the battery; avoid contact.
If contact accidentally occurs, flush with water. If liquid contacts eyes,
additionally seek medical help. Liquid ejected from the battery may cause
irritation or burns.
6) Service
a) Have your power tool serviced by a qualified repair person using only identical
replacement parts. This will ensure that the safety of the power tool is maintained.
Special safety warnings applicable to grinding, sanding,
wire brushing or cutting
a) This power tool is intended for grinding, dressing, wire brushing and cutting.
Read all safety warnings, instructions, illustrations, and specifications provided
with this tool. Neglecting to follow all of the instructions listed below can result
in electric shock, fire and/or serious injury.
b) Polishing is not recommended with this power tool. The use of this power tool
to perform tasks for which the tool was not intended, can lead to danger and
personal injury.
c) Do not use accessories which are not intended to be used with this tool and which
are not recommended by the manufacturer. Even if the accessory can be attached
to your power tool, there is no guarantee that it can be used safely.
d) The accessory's rated speed must at least correspond to the power tool's
maximum rated speed. Accessories which rotate faster than their rated speed
can break and shatter.
e) The accessory's outer diameter and size must fall within the rated capacity of
your power tool.
f) The spindle size of the wheels, flanges, and backing plates or other accessories
must fit the spindle on your power tool correctly. Ill-fitting/incorrectly sized
accessories will end up out of balance, vibrate violently, and may lead to loss
of control.
5