Cocraft LXC AG18 Bedienungsanleitung Seite 13

Shatter guard
Note: The shatter guard must always be attached when the machine is used. For cutting
with discs made of bound abrasive material, a special shatter guard (11) is required.
1. Undo the shatter guard screw.
2. The guard has three lugs that fit into
corresponding notches in the gear housing.
Align the guard as shown in the figure and
press the lugs into the notches in the gear
housing.
3. Once the guard is in place you can adjust
it to the appropriate position before
tightening the screw to lock it in place.
4. Make sure that the guard is securely
in place.
Side handle
Attach the side handle to the side most suited for the work you are about to perform.
Battery
Fit an LXC battery to the angle grinder and make sure that it is pushed all the way into
the battery holder.
On/off switch
Note: Carefully read all the safety instructions and warnings above before operating
the angle grinder.
1. Hold the safety switch in.
2. Press the on/off switch to turn the angle grinder on.
3. Release the on/off switch to turn the angle grinder off.
Overload protection and other safety features
The machine/battery has a number of safety features that prevent damage to
the machine and battery during use.
• During short high-load situations the overload protection may turn off the machine/
battery. This protection resets automatically. Release the trigger, wait a few
seconds, ensure that there is no load and restart the machine. The machine should
now function normally again.
• During high-load for extended periods the overheating protection may turn off
the machine/battery. The protection resets itself but the machine cannot be
restarted until it has returned to normal operating temperature. Let the machine
cool properly before trying to restart it. Adverse temperatures can occur in direct
sunlight and should therefore be avoided.
• The battery has low-voltage protection which comes into effect when the battery
becomes discharged. The low-voltage protection turns off the machine
automatically and the battery should then be recharged.
13